"ERROR" Message When Sending Fleet CLI Commands to a Digi TransPort WR44

Certain Digi TransPort WR44® routers come with a Fleet card.  Under certain circumstances during configuration or management,  the router might report "ERROR" to a Fleet CLI command.

First, verify that the Fleet card is correctly powered as described in the hardware guide here: https://www.digi.com/resources/documentation/digidocs/pdfs/90001245.pdf
on Page 8

If the Fleet card is not properly connected as described in the guide, the router will not detect it and any Fleet CLI commands will show "ERROR".

One easy way to confirm that the Fleet card is correctly detected by the router is to issue the "tags" command:

WR44v2
wr44v2-L
LW
DUALSIM
SIERRA_LTE
W_LAN
L00
123456
OK

If L00 is shown, then the Fleet card is correctly powered and detected. Fleet CLI commands will work.

If E00 is shown, the Fleet card is not detected by the router. Fleet CLI commands will report "ERROR"
Either it is not correctly powered or it is faulty. Please contact Digi Technical Support at tech.support@digi.com for further troubleshooting.


 
Last updated: Jan 28, 2020

Filed Under

Cellular/Transport

Recently Viewed

No recently viewed articles

Did you find this article helpful?