You are viewing an article about an obsolete product. Information on this page is provided as-is and not supported.

How to Enable GPS on a Digi TransPort WR21 with the MC7354 module

NOTE: This article only applies to Digi TransPort WR21 models fitted with the MC7354 cellular module, and a SMA GPS antenna connector populated on the device. Firmware revision 5.2.10.7 or higher is also needed for this function to work.

1) Open a Telnet or SSH session to the command line of the Digi Transport.
2) Issue the following commands at the CLI:

cmd x gpson on (where x is the modemcc 0 info_asy_add port; on a WR21 it should be 4)
gps 0 gpson on
gps 0 init_str $GPS_START

gps 0 asy_add x (where x is the modemcc 0 info_asy_add port)
saveall
reboot


3) To verify that the configuration is working, log into the Web Interface and navigate to Management - Position > GPS.  The GPS coordinates should be displayed, as shown in the screenshot below:

User-added image

Last updated: Mar 04, 2019

Filed Under

Cellular/Transport

Recently Viewed

No recently viewed articles

Did you find this article helpful?